Churchill 3" Gun Carrier

In September 1941, rumors of new German heavy tanks in development led the General Staff to request the Tank Board to produce cruiser and infantry tanks mounting large-caliber high-velocity guns specifically for engaging heavy German tanks.

The Challenger cruiser tank ran into difficulties and only a small number saw service in 1944 and 1945, although the turret was fitted to the TOG 2* heavy tank. The A22 Churchill infantry tank was the obvious candidate for a heavily-armed infantry tank.

Unfortunately the need to fit through rail tunnels meant that the turret ring on the Churchill was too small for a turret capable of mounting a bigger gun. The answer was to fit the gun in a limited-traverse mounting in the hull, resulting in the A22D. While this had tactical disadvantages, the resulting tank could be built in short order.

As the 17 pdr selected for the Challenger would not be available for some time, the old 3” anti-aircraft gun was selected instead. Plenty of these were available after having been replaced in anti-aircraft units by the new 3.7” gun.

Originally 100 vehicles were planned, but in December 1941 it was decided that most Churchill production should focus on tanks fitted with the new 6 pdr gun, and the order was reduced to 24. The first prototype was ready in February 1942 and the remainder of the first production run was finished in the middle of the year.

Fitting the OQF 3” anti-aircraft gun in a limited-traverse mounting on the Churchill infantry tank was a quick way to field a weapon capable of knocking out a Tiger heavy tank. On hearing rumors that the German Tiger tanks were in the area, some infantry colonels have actually refused to attack unless they had Gun Carriers in support.